Splice extension cord code#
The MSHA standard, located in volume 30 of the Code of Federal Regulations, Section 75.517, provides that "power wires and cables.shall be insulated adequately and fully protected."Ī mine employer complies with this standard by "insulating adequately and fully protect" the cord. The standard that applies in mines is different from the OSHA standard. Department of Labor's Mine Safety and Health Administration (MSHA) permits the taping of damaged flexible cords in mines, which are, in many cases, very hazardous environments. MSHA has a different standard governing the repair of flexible cords 12 or larger may be repaired if spliced so that the splice retains the insulation, outer sheath properties, and usage characteristics of the cord being spliced." This standard precludes the repair of flexible cords smaller than No. In addition, Section 1926.405(g)(2)(iii) states that "flexible cords shall be used only in continuous lengths without splice or tap. Therefore, tape repairs of the jacket may not be used to bring a worn or frayed flexible cord into compliance. Taped repairs usually will not duplicate the cord's original characteristics in most cases neither the jacket's strength nor flexibility characteristics will be restored. Also, the jacket is designed both to prevent damage to the conductors and insulators inside and to further insulate the conductors. This is of particular concern with respect to the grounding wire. As noted above, taping the cord can change the flexibility characteristics of the cord, which in turn can affect the amount of stress in the adjacent areas. The original approval of the cord was based on the types of materials and construction used.
Section 1926.403(a) requires that the cord be approved. Two provisions of the standard prohibit the repair of the jacket of a worn or frayed flexible cord with electrical tape. Repair or replacement of a flexible cord (depending on its gauge) is required when the outer jacket is deeply penetrated (enough to cause that part of the cord to bend more than the undamaged part) or penetrated completely, or when the conductors or their insulation inside are damaged. Tape may not be used to repair significant damage to cord jackets Damage to an extension cord that is bad enough to consider taping may have caused damage beyond the jacket. It should also be kept in mind that the heavy-duty extension cords commonly used on construction sites are designed to withstand a hostile environment. Second, the depth of the abrasions and cuts cannot be monitored to see if they get worse without removing the tape. Applying electrical tape that is too thick or applying too much of it could change the cord's original flexibility and lead to internal damage. First, Section 1926.403(a) requires that "all electrical conductors and equipment shall be approved." This standard precludes the use of approved electrical conductors and equipment if their characteristics are significantly altered. While taping these incidental abrasions and cuts does not necessarily violate any OSHA standard, we recommend that employers not tape this type of damage for two reasons. Section 1926.416(e)(1) provides that "worn or frayed electrical cords or cables shall not be used." Superficial nicks or abrasions - those that only slightly penetrate the outer jacket of a flexible cord, and do not permit the cord to bend more in that area than in the rest of the cord - do not normally render a cord "worn or frayed." Therefore, there is no need to repair or replace such a cord. You ask whether there is any prohibition against putting electrical tape over these kinds of abrasions and nicks when there is no damage beyond the jacket - the conductors have not been scraped or exposed and the insulation inside the jacket has not been displaced or compressed.
Generally, electrical tape may be used to cover superficial damage to cord jackets We apologize for the lateness of this reply.
This is in response to your letter of March 20, and your follow-up letter of October 9, concerning the use of electrical tape to repair minor damage (abrasions and cuts of limited depth) on the outer jacket of an extension cord.
0 kommentar(er)
